HP ATP FlexNetwork Solutions Sample Questions:

1. A customer is implementing an access layer solution with four HP Comware switches in an IRF topology. The customer expects to add two additional switches of the same model. What must the customer do when adding the new switches?

A) Implement a daisy chain topology to provide better resilience.
B) Verify that the switch model supports at least six switches in an IRF topology.
C) Enable spanning tree prevent Layer 2 loops for the newly added switches
D) Create a second IRF domain for the two new switches.

2. Which type of access is considered an In-band management connection?

A) Dial-up to an auxiliary port
B) SSH from a desktop to the device
C) Serial connection to Console port
D) Telnet to an HP iLO management port

3. A network administrator configures this command on an HP ProVision Switch: Vlan 30 ip helper-address 10.0.3.253
After the network administrator configures the command, using in VLAN 30 report that their PCs fail to acquire addresses using DHCP. Which command must the network administrator add to the ProVision switch configuration to solve this problem?

A) DHCP enable
B) IP helper-address enable
C) IP routing
D) DHCP-relay

4. Refer to the Exhibit.
Exhibit: HP Comware switch configuration.
[Comware] vlan 100 [Comware-vlan100] quit [Comware] vlan 200 [Comware-vlan200] quit [Comware] interface g1/0/22 [Comware-GigabitEthernet1/0/22] port link-type trunk [Comware-GigabitEthernet1/0/22] port trunk permit vlan 100 200 [Comware-GigabitEthernet1/0/22] quit
A network administrator configures the Comware switch, as shown in the exhibit. The network administrator then connects a cable from the Comware's g1/0/22 interface to port 5 on an HP ProVision switch. Which configuration will successfully establish connection for VLAN 1, 100, and 200 between the two switches?

A) ProVision (config) # vlan 100 200 ProVision (config) # vlan 100 200 tagged 5
B) ProVision (config) # vlan 100 ProVision (config) # vlan 200 ProVision (config) # interface 5 tagged 100 200
C) ProVision (config) # vlan 100 ProVision (config) # vlan 200 ProVision (config) # vlan 100 tagged 5 ProVision (config) # vlan 200 tagged 5
D) ProVision (config) # vlan 100 ProVision (config) # vlan 200 ProVision (config) # interface 5 tagged 100 ProVision (config) # interface 5 tagged 200

5. A customer is implementing a network using HP ProVision switches. Which default setting applies to the ProVision switches?

A) Routing is enabled
B) SSH is enabled
C) A static IP address is assigned to VLAN 1
D) All Ports are disabled

Solutions: