HP BladeSystem Administration Sample Questions:

1. HOTSPOT
Place the markers on the four positions HP recommends to install fans using the "Four-fan rule."

2. Which two components of a server profile can be set to "HP Predefined" to make the profile hardware independent? (Select two.)

A) SAN definitions
B) Link aggregation
C) MAC addresses
D) WWIDs
E) VLANs

3. A customer recently ordered an expansion blade for a server that has an existing mezzanine card in slot 2. When placing the order, the customer was required to get an HP PCI Express Mezzanine Pass-Thru card. Which two rules must the customer follow when installing the expansion blade and mezzanine card? (Select two.)

A) The new mezzanine card needs to be placed in mezzanine slot 3 to avoid moving the existing card The new mezzanine card needs to be placed in mezzanine slot 1 because it is a Type 1 card.
B) A coupler plate must be used if a half-height server will be above the expansion blade.
C) A coupler plate must be secured to the server and expansion blades to make one unit for insertion and removal.
D) The mezzanine card in slot 2 needs to be moved to slot 3 in order to install the new card.

4. What are the three bit settings on interconnects for Thermal Logic management on the HP BladeSystem C7000 enclosure? (Select three.)

A) Cool
B) Hot
C) Alert
D) Warm
E) Critical
F) Good

5. You are installing components into a new HP BladeSystem c7000 enclosure and notice that the HP ProLiant BL660c Gen8 server blade has one mezzanine card, a Fibre Channel HBA, in mezzanine slot 1. The enclosure has Fibre Channel switches in interconnect bays 5 and 6 for redundancy What should you do now to avoid configuration errors? (Select two.)

A) Move the mezzanine card to mezzanine slot 3.
B) Move the switches to interconnect bays 3 and 4.
C) Move the switch in bay 6 to bay 3 for horizontal redundancy.
D) Move the mezzanine card to mezzanine slot 2
E) Move the switches to interconnect bays 1 and 2.

Solutions: