Huawei HCIP-Routing&Switching-IERS(Huawei Certified ICT Professional-Implementing Enterprise Routing and Switching Network) Sample Questions:

1. When the Hold Time supported by the two BGP neighbors are inconsistent, the neighbors negotiate the lowest Hold Time interval that the two ends can support.

A) False
B) True

2. Which description about the characteristics of the routing policy is correct?

A) Apply application command policy-based-route.
B) Based on the forwarding plane, service for forwarding strategy.
C) Forwarding based on the destination address according to the routing table
D) Manual hop-by-hop configuration is required to ensure that packets are forwarded according to policies.

3. Advertise the route to the IBGP peer, and configure its own address as the next hop with

A) neighbor x.x.x.x next-hop-self
B) neighbor x.x.x.x next-hop-local
C) peer x.x.x.x next-hop-local
D) peer x.x.x.x next-hop-self

4. Compared to STP, the RSTP protocol defines different port states, including Discarding and Learning. About the description of the two port states, the correct is: (Multiple Choice)

A) All ports in Discarding state and Learning state do not learn MAC address table
B) The ports in these two states do not forward data frames.
C) Ports in the Learning state do not learn the MAC address table.
D) Ports in Discarding state do not learn the MAC address table.

5. The statement about the device SWC, which is correct?
[SWC]STP INSTANCE 1 PRIORITY 4096
[SWC]INTERFACE ETHERNET 1/0/12
[SWC-ETHERNER 1/0/12]STP POINT-TO-POINT FORCE-TRUE
[SWC]INTERFACE ETHERNET 1/0/2
[SWC-ETHERNET1/0/2]STP EDGED-PORT ENABLE

A) stp point-to-point force-true command is used to identify that the link connected to ETHERNET1/0/13 is point-to-point link.
B) SWC is the root switch
C) stp edged-port enable command is to enable Ethernet 1/0/2 of the switch SWC as an edge port.
D) stp instance 1 priority 4096 is the priority of the configuration switch in instance 1 is 4096, the priority defaults to 0.

Solutions: