Citrix WANScaler 4.2: Administration Sample Questions:

1. An administrator needs to configure the IP address of the apA accelerated interface of a WANScaler appliance from the serial interface. Which command should the administrator use to specify the IP address?

A) IP Address 192.168.100.1
B) Add IP Address 192.168.100.1
C) Address 192.168.100.1
D) Set IP Address 192.168.100.1

2. Scenario: A humanitarian organization is delivering food supplies to a disaster area, and the logistic team needs access to a database at their headquarters in order to determine the food supply inventory. The network traffic from the disaster area to the headquarters is TCP-based. The Network Administrator has been instructed to ensure, if the requirement exists, that the TCP accelerated traffic in this environment has access to 90% of the 1.5 Mbps WAN link.
Which bandwidth management rate will ensure that 90% of the bandwidth is assigned to accelerated traffic regardless of packet loss?

A) Softboost
B) Hardboost
C) Full bandwidth
D) Partial bandwidth

3. Which two WANScaler appliance settings are required when configuring WCCP, using GRE encapsulation? (Choose two.)

A) The IP address of the WAN router
B) The MAC address of the WAN router
C) The service group ID assigned to the WANScaler appliance
D) The VRRP ID assigned to the WANScaler appliance

4. Which two network interface settings must an administrator match for proper operation of devices physically connected to the WANScaler appliances? (Choose two.)

A) Port speed
B) Duplex setting
C) VLAN ID
D) Flow control

5. When an administrator tries to authenticate to a WANScaler appliance that has TACACS+ authentication enabled, the __________. (Choose the correct phrase to complete the sentence.)

A) TACACS+ server is always queried
B) default password of 'wanscaler' must be used
C) WANScaler Controller continues to query the WANScaler appliance
D) locally-defined password can be used

Solutions: