Avaya Aura(TM) Communication Manager and CM Messaging (R6.0) Implementation Sample Questions:

1. Which three commands are port of Avaya Aura CM_survRemote_Embed templates?
(Choose three)

A) Utility services
B) AES 6.0
C) CM 6.0
D) Session manager
E) CMM 6.0

2. A user at extension 1111 complaints that when dialing extension 2222, the call is the call is unexpectedly answered by a person at extension 3333. All other calls made are connected as expected. There is not display on the phone. While at the SAT, the technician has the user repeat the call to extension 2222
Which command identifies the reason this phone call is behaving in the expected way?

A) Display station 3333
B) List trace station 1111
C) Status station 1111
D) List trace station 3333

3. When troubleshooting a system fault, if the web interface or SAT are unavailable, which method should be used?

A) TTY2
B) SAL
C) CLI
D) MODEM

4. A customer has a communication Manager R6.0 system with IP phones and some older TDM phone, and says there is no dial tone for all of the IP phones. All of the hardware has been verified to be working properly.
Which two steps can be taken to identify the cause of problem? (Choose two)]

A) Verify that the processor Ethernet mode is enabled in the Server.
B) Set a static IP address on a laptop and see if the server can be pined
C) Verify that the TN2602 Media resources circuit pack has the correct IP settings.
D) Set a static IP address on a laptop and see if the TN2602 Media Resource circuit pack can be pinged.

5. When using the Avaya Site Administration GSDI interface, which command would be use to built a new telephone set with the extension of 1000?

A) Add station 1000
B) New station 1000
C) Add set 1000
D) Build station 1000

Solutions: